Category: Radio Antennas

GA800 Loop Antenna, Frequency 10Khz-159Mhz Loop Antenna, Low

GA800 Loop Antenna, Frequency 10Khz-159Mhz Loop Antenna, Low Noise, No Tuning Required, Receives High Frequencies (FM, Aviation, Even U/V Band), Suitable for Indoor and Outdoor 【New upgrade features】: Our GA800 antenna has been upgraded with lower noise, strong reception and no tuning requirements. For high frequency (FM, aviation, even U/V segment, etc.) reception, our recommendation is to turn off the power. However, short wave and medium wave need to turn on the power switch, which will help extend the battery life and reduce noise. 【No tuning required】: This magnetic loop antenna has an independent switch, no tuning is required, it...

9ft Starlink Standard Dish RV Ladder Mounting Kit – Pure

9ft Starlink Standard Dish RV Ladder Mounting Kit – Pure 2-inch Aluminum Pole & Universal RV Ladder Mounting Set with Starlink Gen 3 Adapter Included. Product Usage: The STARLINK GEN 3 RV ladder mounting kit is a professional solution specifically designed for the Starlink Gen 3 antenna. It is equipped with a universal metal mounting bracket that is perfectly suitable for ladder rails with a diameter of 0.5 to 1.2 inches, providing extensive applicability for installation. Product Components: This Starlink Gen 3 mounting kit contains three aluminum tubes with a diameter of 2 inches and a thickness of 0.06 inches....

WM-1002A Analog SWR and Watt Meter 1.6-60 MHz 30/300/3KW

WM-1002A Analog SWR and Watt Meter 1.6-60 MHz 30/300/3KW SO-239 Large meter display for ease of reading Forward RF power readings (Switchable to indicate either average power or Peak Envelope Power [PEP], for SSB, AM, CW transmitters) Reversed RF power readings Illuminated meter Pigtail DC power cable › Check Offer Price The Intellitron WM-1002A is an excellent addition to your setup, serving as a SWR (Standing Wave Ratio) and Power Meter. This device is designed to provide valuable insights into the efficiency and performance of your radio frequency (RF) system. By measuring SWR, it helps evaluate how well your antenna...

Receive Transmit HF VHF UHF MW SW HF AIR FM FRS GMRS Antenna

Discone Antennas D3000N/ Diamonds Scanner Antenna/CB UHF VHF

Discone Antennas D3000N/ Diamonds Scanner Antenna/CB UHF VHF Antennas 25-3000MHz for Scanner SDR Radio, Receive Transmit HF VHF UHF MW SW HF AIR FM FRS GMRS Antenna The Discone Antennas (25 to 3000 MHz)are ultra wideband antennas support ham amateur radio, two-way radio, air traffic control SDR programs, CB radio and various frequency bands-MW/ SW/ HF/ CB/ AIR/ UHF/ VHF/ FM/ FRS/ GMRS/ 1090MHz/ 978MHz/ 27MHz. Installation location: On the balcony railing of an apartment or apartment, on the roof or on a mast. If don't need 25-50 MHz reception, you Can be made further compact and lightweight by removing...

Antenna Assembly Manual Type Fits for Toyota Tacoma

Antenna Assembly Manual Type Fits for Toyota Tacoma 2005-2015, All in One Antenna Repair Kit with Antenna & Nut & Base & Ornament Widely Compatible: This kit fits for 2005-2015 Toyota Tacoma. Replace Part Number: antenna base replace #86300-04070, antenna pole replace #86309-04110, nut replace #86396-04040, antenna ornament replace #86392-04040 Improve Signal Reception Quality: The antenna kit is designed to capture radio signals, significantly improving your radio experience, ensuring you can listen to AM and FM radio stations clearly while driving without worrying about signal interference or loss Powerful Function: Antenna pole provides the best capture of radio signals. Antenna...

MMDVM Hotspot Spot Assembled Radio Station OLED Antenna WiFi

MMDVM Hotspot Spot Assembled Radio Station OLED Antenna WiFi Digital Voice Modem P25 DMR YSF Raspberry Pie Pi MMDVM hotspot supports D-STAR DMR YSF P25 NXDN POCSAG, enables the different mode of digital two way radio to communicate with each other (YSF2DMR / YSF2NXDN / YSF2P25 / DMR2YSF / DMR2NXDN) and works great with UHF. HOTSPOT size: 2.8 x 1.3 x 0.9” inch Setup: Set the same freq as Radio Mobile, for example: 433.550000MHZ. DMR WIFI SSID:pi-star,PASSWORD:raspberry. Need the 2.4GHz SSID as the Pi Zero W. doesn't support 5.8GHz Power Supply: Mobile charger or a USB cable connected to your...