Carbusonic Dark Brown convertible roof dye, soft top hood and canvas restorer, restores colour to fabrics.

• Carbusonic MB7533, MMCA4, WW12 Fabric Mould and mildew remover, dark brown canvas dye kit and Water proofing Products are specially formulated products including acrylic co-polymer, silicone and Bio surfactants to make old, faded, fabric convertible tops, RV and boat covers look like new. A permanent, water based dye that may be applied with either a nylon paint brush, sponge, disposable foam brush or diluted further in an air brush and dries in 2-3 hours.
• Directions of use. First Clean the surface thoroughly with detergent and mould remover Carbusonic MMCA4 using a scrubbing action, rinse and then allow it to dry completely. Next use masking tape to mask off the rear window, glass and body work.
• Start the application of Carbusonic MB7533 at the centre section of the front of the top. Work from side to side, progressing towards the back, maintaining a "wet edge" as you work towards the rear. (The technique is similar to painting with water based paint). Immediately remove any drips on paint, glass or trim with a wet cloth
• If the top is badly faded, apply a second coat after 24 hours drying time. Use heat gun or hairdryer to seal dye then allow the final coat of dry for 8 hours and then follow with two coats of waterproofing solution. Carbusonic WW12 Silicone weather proofing. (This Waterproofing Must Be Completely Dry Before Using In Wet Weather). DO NOT use on Vinyl, Acrylic or vinyl impregnated fabric tops. Test small patch for colour first can be diluted with small amount of water.
• After application use a hot air gun or hairdryer to heat the fabric and seal in the dye, apply waterproofing spray supplied in the kit allow to dry before using

Carbusonic MB7533 Dark Brown canvas dye concentrate.

Air drying, thermo-setting co-polymer acrylic . Clean the surface thoroughly with detergent cleaner and then allow it to dry completely. Use Masking Tape to mask off the rear window, the glass and body work. Start the application at the centre section of the front of the top. Work from side to side, progressing towards the back, maintaining a “wet edge” as you work towards the rear. (The technique is similar to painting with water based paint). Immediately remove any drips on paint, glass or trim with a wet cloth. If the top is badly faded, apply a second coat after 24 hours drying time. Allow the final coat of dry for 24 hours and then go over with hair dryer or similar to harden dye, follow with a coat or two of water proofer such as Carbusonic Silicone weather proofer. DO NOT use on vinyl or vinyl impregnated fabric tops. Test small patch for colour first can be diluted with small amount of water.