Rems 578328 Pressing Pliers ,Silver, 15 'Mini

• Box contents: Crimping Pliers in box
• ‘Exclusively for use with a REMS Radial press mini press “

REMS Mini / REMS Crimping Pliers Accessories for REMS Mini-Press ACC, REMS Mini-Press 22 V ACC and REMS Mini-Press S 22 V ACC

• For all standard press fitting systems.
• Heavy duty crimping pliers / press rings made of tough, especially hardened special steel.
• The pressing contours of the REMS crimping pliers / press rings are system-specific and corresponding pressing contours of the respective press fitting systems. This makes it perfectly system-compliant, safe pressing.
• Pressing jaws of the crimping pliers / press rings with high-precision machining centres and precisely rounded press contour. Therefore low manufacturing tolerances.
• Powered by REMS Mini-Press ACC, REMS Mini-Press 22V ACC and REMS Mini-Press S 22V ACC. Read and observe installation instructions of the system provider/manufacturer.
• REMS mini crimping pliers with 2 pivoting monoblock pressing jaws. Particularly compact design and low weight of the REMS mini crimping pliers thanks to the special arrangement of the crimping pliers connection (Patent EP 1 952 948).
• Recesses embedded into the press jaws for safe guidance of the connecting tabs for offset-free pressing (Patent EP 2 347 862). REMS crimping pliers mini ACz, Fz, HEz, RFz, RFID with teeth prevent burrs formation on the press sleeve (patent EP 2 027 971).
• REMS press ring 45° (PR-2B), with 2 press jaws, for safe attachment of the press jaws in hard-to-reach places thanks to 45° inclined position (Patent EP 2 774 725).
• Drive with intermediate pliers.

Traceability according to EN 1775:2007.

REMS mini crimping pliers with press contour F, M, V, SA, B, RN and UP each have a specific marking incorporated into the press contour, which leaves a permanent impression directly on the pressed fitting after the pressing process. This allows the user to check even after the pressing process whether the suitable crimping pliers have been used to manufacture the press connection. With this traceability, REMS meets the recommendations of the European standard EN 1775:2007 when installing pressure fitting systems for gas.